two-ply tissues.
2.2.2
Grab Bar (GB)
Grab bar shall be 18 gauge, 32 mm 1-1/4 inches OD Type 304 stainless steel.
Grab bar shall be form and length as indicated. [Concealed] [Exposed]
mounting flange shall have mounting holes concealed. Grab bar shall have
[satin finish] [peened non-slip surface]. Installed bars shall be capable
of withstanding a 2.225 kN 500 pound vertical load without coming loose
from the fastenings and without obvious permanent deformation. Space
between wall and grab bar shall be 38 mm. 1-1/2 inch.
2.2.3
Medicine Cabinet (MC)
Medicine cabinet shall be constructed with cold-rolled carbon steel sheet
of not less than 0.76 mm .03 inch thick, formed from a single sheet of
steel or shall have mechanically formed spot welded or any other suitable
joints. Width, height and depth of cabinet shall be in accordance with
paragraph SCHEDULE.
2.2.3.1
Sliding Door Cabinet, Class 1
Sliding door cabinet assembly shall be [surface mounted vanity] [recessed
cabinet] with design and lighting arrangement as indicated. Cabinet shall
have a minimum of 2 shelves. The mirror shall have [a wide frame] [a
narrow frame] [no frame].
2.2.3.2
Swinging Door Cabinet, Class 2
Swinging door cabinet assembly including the lighting arrangement shall be
as indicated. Assembly shall be [surface] [recess] mounted. Cabinet shall
be located centrally behind the door and shall contain a minimum of two
shelves. Door hinges shall be stainless steel or carbon steel. Magnets
used in door catches shall be permanent type. Doors shall be [with]
[without] a mirror.
2.2.4
Mirrors, Glass (MG)
Glass for mirrors shall be Type I transparent flat type, Class 1-clear.
Glazing Quality q1 6 mm 1/4 inch thick conforming to ASTM C 1036. Glass
shall be coated on one surface with silver coating, copper protective
coating, and mirror backing paint. Silver coating shall be highly adhesive
pure silver coating of a thickness which shall provide reflectivity of 83
percent or more of incident light when viewed through 6 mm 1/4 inch thick
glass, and shall be free of pinholes or other defects. Copper protective
coating shall be pure bright reflective copper, homogeneous without sludge,
pinholes or other defects, and shall be of proper thickness to prevent
"adhesion pull" by mirror backing paint. Mirror backing paint shall
consist of two coats of special scratch and abrasion-resistant paint and
shall be baked in uniform thickness to provide a protection for silver and
copper coatings which will permit normal cutting and edge fabrication.
2.2.5
Mirror, Metal (MM)
Metal mirror shall be bright polished stainless steel, mirror quality, 0.94
mm 0.037 inch minimum thickness, edges turned back 6 mm 1/4 inch and recess
fitted with tempered hardboard backing, and theft-proof fasteners. Size
shall be in accordance with paragraph SCHEDULE.
SECTION 10800
Page 9
Previous Page
