PART 2
PRODUCTS
2.1
GENERAL
**************************************************************************
NOTE: All paragraphs must be carefully edited
because of the broad number of possible requirements
and the diverse combinations available with these
products.
**************************************************************************
To the maximum extent possible, corner guards, door and door frame
protectors, wall guards (bumper guards), wall panels and wall covering
shall be the standard products of a single manufacturer and shall be
furnished as detailed. Drawings show general configuration of products
required, and items differing in minor details from those shown will be
acceptable.
2.1.1
Resilient Material
Resilient material shall consist of high impact resistant extruded acrylic
vinyl, polyvinyl chloride, or injection molded thermal plastic and shall
conform to the following:
2.1.1.1
Minimum Impact Resistance
Minimum impact resistance shall be 960.8 N.m/m (18 ft. lb/sq. inch) 18 ft.
lbs/sq. inch when tested in accordance with ASTM D 256, (Izod impact, ft.
lbs per sq inch notched).
2.1.1.2
Fire Rating
Fire rating shall be Class 1 when tested in accordance with ASTM E 84,
having a maximum flame spread of 25 and a smoke developed rating of 450 or
less. Material shall be rated self extinguishing when tested in accordance
with ASTM D 635. Material shall be labeled and tested by an approved
nationally known testing laboratory. Resilient material used for
protection on fire rated doors and frames shall be listed by the testing
laboratory performing the tests. Resilient material installed on fire
rated wood/steel door and frame assemblies shall have been tested on
similar type assemblies. Test results of material tested on any other
combination of door/frame assembly will not be acceptable.
2.1.1.3
Integral Color
Colored components shall have integral color and shall be matched in
accordance with SAE J1545 to within plus or minus 1.0 on the CIE-LCH scales.
2.1.1.4
Chemical and Stain Resistance
Materials shall be resistant to chemicals and stains reagents in accordance
with ASTM D 543.
2.1.1.5
Fungal and Bacterial Resistance
Materials shall be resistant to fungi and bacteria in accordance with ASTM
G 21 or ASTM G 22, as applicable.
SECTION 10260
Page 7
Previous Page
