2.3.1.3
Handrails
Handrails shall consist of snap-on covers of high impact resistant
resilient material, minimum 1.98 mm 0.078 inch thick on a continuous
extruded aluminum retainer, minimum 1.83 mm 0.072 inch thick anchored to
wall at maximum 800 mm 32 inches on center. Handrails shall be provided
with prefabricated end closure caps, inside and outside corners, concealed
splices, cushions, mounting hardware and other accessories standard with
the manufacturer. End caps and corners shall be field adjustable to assure
close alignment with handrails.
2.4
DOOR PROTECTORS
[Door] [Door envelope] [Door knob] [and] [door frame] protection items
shall consist of high impact resistant acrylic vinyl or polyvinyl chloride
resilient material, minimum [1.52 mm 0.060 inch thick for doors] [and] [
0.89 mm 0.035 inch thick for door frames]. Coordinate door and door frame
protection material requirements with door and frame suppliers to insure
fit for all components and color matching with other resilient materials.
Provide adhesive as recommended by resilient material manufacturer.
2.5
WALL COVERING/PANELS
**************************************************************************
NOTE: Recommended locations for various thicknesses
of rigid wall covering/panels are as follows: 0.50
to 1.02 mm (0.022 to 0.040 inch) thick for lobbies
and elevator areas, 1.52 to 2.03 mm (0.060 to 080
inch) thick for service corridors, and 2.38 to 3.1
mm (0.093 to 0.125 inch) thick for loading dock
areas. A 9.53 mm (0.375 inch) thick composite wall
panel is recommended for installation over existing
substrates such as ceramic tile, masonry block, or
damaged plaster/drywall.
**************************************************************************
Wall covering/panels shall consist of high impact rigid acrylic vinyl or
polyvinyl chloride resilient material. Panel sizes shall be [0.61 x 2.94
m] [2 x 4 ft.] [_____].
2.5.1
Rigid Vinyl Acrylic Wall Covering
Wall covering thickness shall be [0.56] [0.71] [1.02] [1.52] mm [0.022]
[0.028] [0.040] [0.375] inch.
2.5.2
High Impact Wall Panels
Wall panel face and edge thickness shall be [0.56] [0.71] mm [0.022]
[0.028] inch. Panel face shall be factory banded to a 9.53 mm 0.375 inch
thick fiberboard core. The backside of the panel shall be laminated with a
moisture resistant vapor barrier.
2.6
TRIM, FASTENERS AND ANCHORS
Vinyl trim, fasteners and anchors shall be provided for each specific
installation as shown.
SECTION 10260
Page 9
Previous Page
