Contractor. The manufacturer's representative shall advise on surface
preparation, inspections, surface repair materials and methods, material
handling, batching and mixing, application, curing, and testing.
]1.4.3.7
Joint Sealant Materials
Provide manufacturer's certification of conformance to contract
requirements.
1.4.3.8
Coating Materials
Provide manufacturer's certification of conformance to contract
requirements.
1.4.3.9
Coating System Component Compatibility
Provide certification from each manufacturer of components of the coating
system, epoxy primer, epoxy intermediate, and polyurethane topcoat, that
the supplied coating material is suitable for use in the specified coating
system. Each manufacturer shall identify the specific products, including
manufacturer's name, which their product may be used with. The
certification shall provide the name of the manufacturer that will provide
technical support for the entire system. When all coating materials are
manufactured by one manufacturer, this certification is not required.
1.4.3.10
Non-metallic Abrasive
Provide manufacturer's certification that the materials are currently
approved by the Naval Sea Systems Command and listed on the Qualified
Products Lists (QPL) for the specified materials.
1.4.3.11
Metallic Abrasive
Provide manufacturer's certification of conformance to contract
requirements and provide copies of test results.
1.4.4
Product Data
1.4.4.1
Joint Sealant Instructions
Submit manufacturer's printed instructions including detailed application
procedures, minimum and maximum application temperatures, and curing
procedures. Include materials safety data sheets (MSDS) for materials to
be used at the job site in accordance with 29 CFR 1926.59.
1.4.4.2
Coating System Instructions
Submit manufacturer's printed instructions including detailed mixing and
application procedures, number and types of coats required, minimum and
maximum application temperatures, and curing procedures. Include materials
safety data sheets (MSDS) for materials to be used at the job site in
accordance with 29 CFR 1926.59.
1.5
DELIVERY AND STORAGE
Ship, store, and handle materials in accordance with SSPC PA 1, and as
modified in this Section. Maintain temperature in storage spaces between 5
and 24 degrees C 40 and 75 degrees F, and air temperature more than 3
degrees C 5 degrees F above the dew-point at all times. Inspect materials
SECTION 09971
Page 15
Previous Page
