manufacturer, an equivalent color by another
manufacturer may be submitted for approval.
Manufacturers and materials specified are not
intended to limit the selection of equal colors from
other manufacturers. The word "color" as used
herein includes surface color and pattern."
When more than one type, pattern or color is
specified identify location and extent of work for
each.
When a manufacturer's name, stock number, pattern,
and color is used, be certain that the product
conforms to this specification, as edited.
Prior to specifying a custom color finish, research
to determine if additional cost is feasible. Note
there is often a minimum order requirement; this
requirement will also affect future orders.
**************************************************************************
Unless otherwise noted, color shall be [in accordance with Section 09915
COLOR SCHEDULE] [as indicated on the drawings] [selected from manufacturers
standard colors] [[______]. Color listed is not intended to limit the
selection of equal colors from other manufacturers].
PART 3
EXECUTION
3.1
EXAMINATION
Contractor shall inspect all areas and conditions under which wallcoverings
are to be installed. Contractor shall notify the Contracting Officer in
writing of any conditions detrimental to the proper and timely completion
of the installation. Work will proceed only when conditions have been
corrected and accepted by the installer.
3.2
SURFACE PREPARATION
**************************************************************************
NOTE: When applying wallcovering over concrete or
masonry surfaces, Section 03300 CAST-IN-PLACE
STRUCTURAL CONCRETE or Section 03300N CAST-IN-PLACE
CONCRETE, and Section 04200 MASONRY, will be
coordinated to require, as applicable: (1) smooth
concrete finish (2) masonry surfaces that are level
and plumb with flush joints and square openings and
(3) no variations in the surfaces exceeding 1 mm in
1000 mm (1/8 inch in 10 feet) with no abrupt
irregularities.
Coordinate level of gypsum wallboard finish required
for presentation dry erase wallcovering with Section
09250 Gypsum Wallboard. Some manufacturers require
a Level 4 finish and others Level 5.
When mold is a problem in an existing building that
is being renovated add verbiage to specification to
cover removal of mold and appropriate surface
preparation necessary to install new wallcovering.
SECTION 09720
Page 13
Previous Page
