ASTM C 645
(2004a) Nonstructural Steel Framing Members
ASTM C 754
(2004) Installation of Steel Framing
Members to Receive Screw-Attached Gypsum
Panel Products
ASTM C 841
(2003) Installation of Interior Lathing
and Furring
ASTM C 842
(1999) Application of Interior Gypsum
Plaster
ASTM C 843
(1999e1) Application of Gypsum Veneer
Plaster
ASTM C 844
(2004) Application of Gypsum Base to
Receive Gypsum Veneer Plaster
ASTM C 847
(1995; R 2000) Metal Lath
ASTM C 897
(2000) Aggregate for Job-Mixed Portland
Cement-Based Plasters
ASTM C 926
(1998a) Application of Portland
Cement-Based Plaster
ASTM C 933
(2004) Welded Wire Lath
ASTM C 955
(2003) Load-Bearing (Transverse and Axial)
Steel Studs, Runners (Tracks), and Bracing
or Bridging for Screw Application of
Gypsum Panel Products and Metal Plaster
Bases
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
submittal is sufficiently important or complex in
context of the project.
For submittals requiring Government approval on Army
projects, a code of up to three characters within
the submittal tags may be used following the "G"
designation to indicate the approving authority.
Codes for Army projects using the Resident
Management System (RMS) are: "AE" for
SECTION 09200A
Page 6
Previous Page
