SD-05 Design Data
Load calculations; G
SD-06 Test Reports
Structural performance; G
Panel finish; G
Submit reports of the tests required by this section.
Manufacturer's field inspection; G
Submit manufacturer's technical representative's inspection
reports as required in paragraph entitled "Manufacturer's Field
Inspection."
SD-07 Certificates
Technical representative
Qualification of Installer
Submit documentation proving the installer is factory-trained,
has the specified experience and is authorized by the manufacturer
to install the products specified.
Coil stock compatibility; G
Provide certification of coil compatibility with roll forming
machinery to be used for forming panels without warping, waviness,
and rippling not part of panel profile; to be done without damage,
abrasion or marking of finish coating.
SD-08 Manufacturer's Instructions
Sealant
Submit manufacturer's sealant requirements for making the
standing seam watertight when subjected to 125 mm 5 inches of
rainfall per hour simultaneous with [160] [200] [_____] km/h [100]
[124] [_____] mph winds.
Installation manual; G
Submit manufacturer's printed installation manual/instructions
and standard details.
SD-11 Closeout Submittals
Information card
For each roofing installation, submit a typewritten card or
photoengraved aluminum card containing the information listed on
Form 1 located at the end of this section.
SECTION 07612N
Page 11
Previous Page
