[_____] mph wind.
1.3.2.3
Thermal Movement
**************************************************************************
NOTE: Select the temperature range appropriate for
the finish and color specified.
**************************************************************************
The system shall be capable of withstanding thermal movement based on a
temperature range of 5 degrees C 10 degrees F below design low air
temperature and [60 degrees C140 degrees F for mill finish and light
colors.] [82 degrees C180 degrees F for dark colors.]
1.3.2.4
Deflection
Panel deflection shall not exceed L/140.
1.3.2.5
Structural Performance
The structural performance test methods and requirements shall be in
accordance with ASTM E 1592.
1.4
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
submittal is sufficiently important or complex in
context of the project.
For submittals requiring Government approval on Army
projects, a code of up to three characters within
the submittal tags may be used following the "G"
designation to indicate the approving authority.
Codes for Army projects using the Resident
Management System (RMS) are: "AE" for
Architect-Engineer; "DO" for District Office
(Engineering Division or other organization in the
District Office); "AO" for Area Office; "RO" for
Resident Office; and "PO" for Project Office. Codes
following the "G" typically are not used for Navy
projects.
Submittal items not designated with a "G" are
considered as being for information only for Army
projects and for Contractor Quality Control approval
for Navy projects.
**************************************************************************
SECTION 07612N
Page 9
Previous Page
