attachment should be at much closer spacing than
usual. Copious use of sealants and closure pieces
molded to conform to roof panels is imperative.
6. Building may require equipment such as antennae,
ladders, or lighting installed on roof. Access to
roof-mounted mechanical equipment is often required.
Provide walking surfaces and attachment accessories
which do not compromise integrity of roof system.
These accessories should provide support without
penetrating roofing panels. Usually this is done
with clamps attached to standing seam, or other
specially designed clips. Provide curbs for
mechanical equipment.
7. Specify insulation in appropriate Division 07
section.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
ALUMINUM ASSOCIATION (AA)
AA ADM1
(2000) Aluminum Design Manual
AA ASM-35
(2000) Specifications for Aluminum Sheet
Metal Work in Building Construction,
Section 5
AMERICAN FOREST & PAPER ASSOCIATION (AF&PA)
AF&PA T101
(2001) National Design Specification
(NDS)for Wood Construction
AMERICAN IRON AND STEEL INSTITUTE (AISI)
AISI SG-973
(1996) Cold-Formed Steel Design Manual
ASTM INTERNATIONAL (ASTM)
ASTM B 117
(2002) Operating Salt Spray (Fog) Apparatus
ASTM B 209
(2004) Aluminum and Aluminum-Alloy Sheet
and Plate
SECTION 07612N
Page 5
Previous Page
