Codes for Army projects using the Resident
Management System (RMS) are: "AE" for
Architect-Engineer; "DO" for District Office
(Engineering Division or other organization in the
District Office); "AO" for Area Office; "RO" for
Resident Office; and "PO" for Project Office. Codes
following the "G" typically are not used for Navy
projects.
Submittal items not designated with a "G" are
considered as being for information only for Army
projects and for Contractor Quality Control approval
for Navy projects.
**************************************************************************
Government approval is required for submittals with a "G" designation;
submittals not having a "G" designation are [for Contractor Quality Control
approval.][for information only. When used, a designation following the
"G" designation identifies the office that will review the submittal for
the Government.] The following shall be submitted in accordance with
Section 01330 SUBMITTAL PROCEDURES:
SD-02 Shop Drawings
Covering on flat, sloped, or curved surfaces; G, [_____]
Gutters; G, [_____]
Downspouts; G, [_____]
Expansion joints; G, [_____]
Gravel stops and fascias; G, [_____]
Splash pans; G, [_____]
Flashing for roof drains; G, [_____]
Base flashing; G, [_____]
Counterflashing; G, [_____]
Flashing at roof penetrations; G, [_____]
Reglets; G, [_____]
Scuppers; G, [_____]
Copings; G, [_____]
Drip edge; G, [_____]
Conductor heads; G, [_____]
Open valley flashing; G, [_____]
Eave flashing; G, [_____]
Indicate thicknesses, dimensions, fastenings and anchoring
SECTION 07600
Page 8
Previous Page
