configuration.
Fasteners;
Two samples of each type to be used with statement regarding
intended use. If so requested, random samples of bolts, nuts, and
washers as delivered to the jobsite shall be taken in the presence
of the Contracting Officer and provided to the Contracting Officer
for testing to establish compliance with specified requirements.
Insulation;
One piece of each type to be used, and descriptive data covering
installation.
Gaskets and Insulating Compounds;
Two samples of each type to be used and descriptive data.
Sealant;
One sample, approximately 1 pound, and descriptive data.
Wall Liners;
One piece, 9 inches long, full width.
SD-05 Design Data
Wind load calculations; G, [_____]
Calculations shall be prepared, signed, and sealed by a
registered structural engineer.
SD-06 Test Reports
Salt Spray Test;
SD-07 Certificates
Wall Panels; G, [_____]
Accessories;
Insulation;
Certificates from the wall panel manufacturer attesting that the
panels and accessories conform to the specified requirements and
are suitable for the installation environment.
SD-08 Manufacturer's Instructions
INSTALLATION; G, [_____]
Submit manufacturer's printed installation manual and
instructions.
SECTION 07413
Page 8
Previous Page
