**************************************************************************
Government approval is required for submittals with a "G" designation;
submittals not having a "G" designation are [for Contractor Quality Control
approval.][for information only. When used, a designation following the
"G" designation identifies the office that will review the submittal for
the Government.] The following shall be submitted in accordance with
Section 01330 SUBMITTAL PROCEDURES:
SD-02 Shop Drawings
Siding; G, [_____]
Drawings consisting of catalog cuts, panel configuration, system
assembly, attachment details, flashing details, design and
erection drawings, shop coating and finishing specifications, and
other data as necessary to clearly describe design, materials,
sizes, layouts, construction details, fasteners, and erection.
Drawings shall be accompanied by engineering design calculations
for the siding panels. Drawings shall be approved by the metal
wall panel manufacturer prior to submission.
SD-03 Product Data
**************************************************************************
NOTE: Edit the product data submission requirements
as necessary for the system specified. Include
bracketed requirements as applicable to the system
being specified.
**************************************************************************
Wall panels; G, [_____]
Closures
flashing
Accessories
Fasteners
Gaskets and Insulating Compounds
SD-04 Samples
WALL PANEL;
One piece of each type and finish (exterior and interior) to be
used, 9 inches long, full width.
Factory-applied Color Finish Charts; G, [_____]
Provide standard [and custom] color charts for wall panel and
accessory color selection.
Accessories;
One sample of each type of flashing, trim, closure, cap and
similar items. Size shall be sufficient to show construction and
SECTION 07413
Page 7
Previous Page
