as necessary for the system specified. Include
bracketed requirements as applicable to the system
being specified.
**************************************************************************
Roof panels; G, [_____]
[
FACTORY COLOR FINISH; G, [_____]]
Accessories
Fasteners
UNDERLAYMENTS
Gaskets and Insulating Compounds
SD-04 Samples
Roof Panels
One piece of each type and finish to be used, 9 inches long,
full width.
Factory-applied Color Finish Charts; G, [_____]
Provide standard [and custom] color charts for roof panel and
accessory color selection.
Accessories
One sample of each type of flashing, trim, fascia, closure, cap
and similar items. Size shall be sufficient to show construction
and configuration.
Fasteners
Two samples of each type to be used with statement regarding
intended use.
Gaskets and Insulating Compounds
Two samples of each type to be used and descriptive data.
Sealant
SD-05 Design Data
**************************************************************************
NOTE: Coordinate with requirements of "Wind Uplift"
paragraph. Include bracketed requirement where
non-rated systems may be permissible.
**************************************************************************
Wind Uplift Resistance; G, [_____]
Engineering calculations [comparing wind uplift calculations
with tested wind resistance][validating the wind resistance of
non-tested roof system]. Calculations shall be prepared, signed,
SECTION 07412
Page 9
Previous Page
