ASTM C 59/C 59M5M
(1997) Blended Hydraulic Cements (Metric)
ASTM C 618
(2003) Coal Fly Ash and Raw or Calcined
Natural Pozzolan for Use as a Mineral
Admixture in Concrete
ASTM C 989
(2004) Ground Granulated Blast-Furnace
Slag for Use in Concrete and Mortars
ASTM D 1894
(2001) Static and Kinetic Coefficients of
Friction of Plastic Film and Sheeting
ASTM D 2240
(2004) Rubber Property - Durometer Hardness
ASTM D 256
(2004) Determining the Izod Pendulum
Impact Resistance of Plastics
ASTM D 4020
(2001a) Ultra-High-Molecular-Weight
Polyethylene Molding and Extrusion
Materials
ASTM D 570
(1998) Water Absorption of Plastics
ASTM D 638
(2003) Tensile Properties of Plastics
ASTM D 638M
(1996) Tensile Properties of Plastics
(Metric)
ASTM D 792
(2000) Density and Specific Gravity
(Relative Density) of Plastics by
Displacement
ASTM F 844
(2004) Washers, Steel, Plain (Flat),
Unhardened for General Use
PRECAST/PRESTRESSED CONCRETE INSTITUTE (PCI)
PCI MNL-116
(1999) Quality Control for Plants and
Production of Structural Precast Concrete
Products
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
submittal is sufficiently important or complex in
context of the project.
SECTION 02395
Page 6
Previous Page
