Follow-up Phase

c.

Establish level of workmanship and verify that it meets minimum

acceptable workmanship standards. Compare with required sample

panels as appropriate.

d.

Resolve all differences.

e.

Check safety to include compliance with and upgrading of the

safety plan and activity hazard analysis. Review the activity

analysis with each worker.

f.

The Government shall be notified at least [_____] hours in advance

of beginning the initial phase. Separate minutes of this phase

shall be prepared by the CQC System Manager and attached to the

daily CQC report. Exact location of initial phase shall be

indicated for future reference and comparison with follow-up

phases.

g.

The initial phase should be repeated for each new crew to work

onsite, or any time acceptable specified quality standards are not

being met.

3.6.3

Follow-up Phase

Daily checks shall be performed to assure control activities, including

control testing, are providing continued compliance with contract

requirements, until completion of the particular feature of work. The

checks shall be made a matter of record in the CQC documentation. Final

follow-up checks shall be conducted and all deficiencies corrected prior to

the start of additional features of work which may be affected by the

deficient work. The Contractor shall not build upon nor conceal

non-conforming work.

3.6.4

Additional Preparatory and Initial Phases

Additional preparatory and initial phases shall be conducted on the same

definable features of work if: the quality of on-going work is

unacceptable; if there are changes in the applicable CQC staff, onsite

production supervision or work crew; if work on a definable feature is

resumed after a substantial period of inactivity; or if other problems

develop.

3.7

TESTS

3.7.1

Testing Procedure

The Contractor shall perform specified or required tests to verify that

control measures are adequate to provide a product which conforms to

contract requirements. Upon request, the Contractor shall furnish to the

Government duplicate samples of test specimens for possible testing by the

Government. Testing includes operation and/or acceptance tests when

specified. The Contractor shall procure the services of a Corps of

Engineers approved testing laboratory or establish an approved testing

laboratory at the project site. The Contractor shall perform the following

activities and record and provide the following data:

a.

Verify that testing procedures comply with contract requirements.

b.

Verify that facilities and testing equipment are available and

SECTION 01451A

Page 12