requirements and that training is adequate. This service shall be
coordinated with the Contracting Officer and the results reported in
writing to the Contracting Officer.
b. During the 11th month of operation an inspection and test of each
system shall be conducted by the system Contractor to identify and correct
any deficiencies before the end of warranty period. A medical facility
representative shall witness this procedure and the system Contractor shall
certify that all necessary corrective actions have been taken.
c. Results of each warranty period inspection and test shall be reported
in writing to the Contracting Officer.
3.6
DEMONSTRATION AND TRAINING
All specified demonstration and training shall be provided at no additional
cost to the Government. This includes all specified onsite training, and
factory training at the Manufacturer's facility.
3.6.1
Training Plan
a. Develop and submit a training plan for approval by the Contracting
Officer. The training plan shall include the basic training requirements
set forth below.
b. Provide training to the medical facility staff in accordance with the
approved training plan.
3.6.2
General Preparations
During the week prior to the start of training for any system, check the
system to assure that it as been commissioned and is in full-specified
operation condition.
3.6.3
Training Personnel
a. Furnish qualified factory trained or certified instructors to train
designated medical facility staff in the operation and maintenance of the
provided system.
b. The Contracting Officer reserves the right to approve the system
Contractor's choice of training personnel, and, upon rejection of a trainer
by the Contracting Officer at any time, the system Contractor shall
immediately replace such trainers. Upon request, the system Contractor
shall provide the Contracting Officer the opportunity to interview and
review the qualifications of each proposed trainer.
3.6.4
Training Instructions
a. Training instructions shall cover all specified features and
capabilities of the system, and all of the items contained in the operating
and maintenance manuals.
b. Maintenance technician training shall also include preventive
maintenance, routine maintenance, repair and troubleshooting procedures.
c. Training shall continue until the system Contractor is advised by the
Contracting Officer that all training has been satisfactorily completed in
accordance with the approved training plan.
SECTION 16730A
Page 43
Previous Page
