**************************************************************************
NOTE: The following information shall be shown on
the project drawings:
1. Where specification identifies type, size,
color, finish, or other definitive information to be
"as indicated," the engineer shall include the
information on the drawings.
2.
Location of ducts, and cables.
3. Types of wire and cable; number and sizes of
conductors.
4. Special conditions.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI C119.1
(2002) Sealed Insulated Underground
Connector Systems Rated 600 Volts
ANSI C2
(1997) National Electrical Safety Code
ASSOCIATION OF EDISON ILLUMINATING COMPANIES (AEIC)
AEIC CS1
(1990) Impregnated-Paper-Insulated,
Metallic Sheathed Cable, Solid Type
AEIC CS5
(1994; CS5a-1995) Cross-Linked
Polyethylene Insulated Shielded Power
Cables Rated 5 Through 46 kV
AEIC CS6
(1996) Ethylene Propylene Rubber Insulated
Shielded Power Cables Rated 69 kV
ASTM INTERNATIONAL (ASTM)
ASTM B 1
(2001) Hard-Drawn Copper Wire
ASTM B 8
(2004) Concentric-Lay-Stranded Copper
Conductors, Hard, Medium-Hard, or Soft
SECTION 16302N
Page 5
Previous Page
