[Six] [_____] copies of complete descriptive specification for
each type and size motor furnished, with necessary cuts,
photographs, and drawings to clearly indicate the construction of
the motor, specifications for the materials and treatments used to
prevent corrosion of parts, and of bearing construction. A
complete listing of motor performance data in the form provided in
NEMA MG 1 paragraph 21.50 shall be submitted. Submittal shall
and control equipment and for operational settings. Information
such as, but not limited to, normal and maximum operating
temperatures for windings and bearings, V-curves, field control
and protective equipment to be mounted on the motor controller
cubicle, locked-rotor current, permissible locked-rotor time,
starting times for each type of start as indicated above, and
subtransient, transient, and synchronous reactance. If duplicate
equipment has not been manufactured previously, calculations or
tests shall be made as necessary and confirmed as required by
paragraph FACTORY TESTS. Contracting Officer's approval shall be
obtained in writing prior to the commencement of manufacture of
motors.
Government Study
[Six] [_____] copies of the specified data.
Spare Parts
The Contractor shall submit a complete list of renewal parts for
the motor. The list shall accompany the instruction manuals.
Antireverse Device[; G][; G, [_____]]
The design of the antireverse device shall be submitted for
approval of the Contracting Officer.
SD-06 Test Reports
[Six] [_____] copies of test reports recording all data,
calculations, and curves shall be furnished to the Contracting
Officer for each motor used.
SD-07 Certificates
Power Factor and Efficiency
[Six] [_____] copies of certification guaranteeing value of
power factor and efficiency for full load, 3/4 full load, and 1/2
full load.
Complete Test
Check Tests
[Six] [_____] certified copies of the results of a "Complete
Test" for duplicate equipment of the respective rating and type
will be accepted in lieu of the "Complete Test" specified for
SECTION 16222A
Page 8