In adapting this specification to any project, the
form and phraseology will be changed as necessary to
properly specify the work contemplated. When
deviations from this specification are considered,
necessary prior approval from HQUSACE will be
obtained.
Instructions for UFGS-15131A VERTICAL PUMPS,
AXIAL-FLOW AND MIXED-FLOW IMPELLER-TYPE, specify
that Section 4 of Part IV, Technical Provisions, be
reserved for insertion of the technical provisions
of this guide specification.
The following should be included in section "L" of
standard form 36, Information to Bidders.
"It is preferred that the field poles be secured to
the rotor structure by means of dovetails, but an
alternate method of construction will be acceptable,
provided that evidence of its adequacy, satisfactory
to the Contracting Officer, is submitted with the
bid."
The designer should consider prequalifying the
bidders based on past experience with this type and
size of motor. Criteria for qualifying should be
included in section "L" of standard form 36.
**************************************************************************
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
ASTM INTERNATIONAL (ASTM)
ASTM A 123/A 123M
(2002) Zinc (Hot-Dip Galvanized) Coatings
on Iron and Steel Products
ASTM A 153/A 153M
(2004) Zinc Coating (Hot-Dip) on Iron and
Steel Hardware
ASTM B 344
(2001) Drawn or Rolled Nickel-Chromium and
Nickel-Chromium-Iron Alloys for Electrical
Heating Elements
SECTION 16222A
Page 5
Previous Page
