ASME INTERNATIONAL (ASME)
ASME B31.1
(2004) Power Piping
ASME B40.100
(2000) Pressure Gauges and Gauge
Attachments
ASME BPVC SEC I
(2001) Boiler and Pressure Vessel Code;
Section I, Power Boilers
ASME BPVC SEC IV
(2001) Boiler and Pressure Vessel Code;
Section IV, Recommended Rules for the Care
and Operation of Heating Boilers
ASME BPVC SEC IX
(2001) Boiler and Pressure Vessel Code;
Section IX, Welding and Brazing
Qualifications
ASME BPVC SEC VIII D1
(2001) Boiler and Pressure Vessel Code;
Section VIII, Pressure Vessels Division 1
- Basic Coverage
ASME PTC 19.3
(1974; R 2004) Temperature Measurement
ASTM INTERNATIONAL (ASTM)
ASTM D 1066
(1997; R 2001) Sampling Steam
ASTM D 2186
(1984; R 1999e1) Deposit-Forming
Impurities in Steam
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
submittal is sufficiently important or complex in
context of the project.
For submittals requiring Government approval on Army
projects, a code of up to three characters within
the submittal tags may be used following the "G"
designation to indicate the approving authority.
Codes for Army projects using the Resident
Management System (RMS) are: "AE" for
Architect-Engineer; "DO" for District Office
(Engineering Division or other organization in the
District Office); "AO" for Area Office; "RO" for
Resident Office; and "PO" for Project Office. Codes
SECTION 15845A
Page 4
Previous Page
