MANUFACTURERS STANDARDIZATION SOCIETY OF THE VALVE AND FITTINGS
INDUSTRY (MSS)
MSS SP-25
(1998) Standard Marking System for Valves,
Fittings, Flanges and Unions
MSS SP-58
(2002) Pipe Hangers and Supports -
Materials, Design and Manufacture
MSS SP-69
(2002) Pipe Hangers and Supports -
Selection and Application
MSS SP-70
(1998) Cast Iron Gate Valves, Flanged and
Threaded Ends
MSS SP-71
(1997) Gray Iron Swing Check Valves,
Flanged and Threaded Ends
MSS SP-80
(2003) Bronze Gate, Globe, Angle and Check
Valves
MSS SP-85
(2002) Cast Iron Globe & Angle Valves,
Flanged and Threaded Ends
PLUMBING-HEATING-COOLING CONTRACTORS NATIONAL ASSOCIATION (PHCC)
NAPHCC NSPC
(2003) National Standard Plumbing Code
UNDERWRITERS LABORATORIES (UL)
UL 94
(1996; Rev thru Dec 2003) Tests for
Flammability of Plastic Materials for
Parts in Devices and Appliances
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
submittal is sufficiently important or complex in
context of the project.
For submittals requiring Government approval on Army
projects, a code of up to three characters within
the submittal tags may be used following the "G"
designation to indicate the approving authority.
Codes for Army projects using the Resident
Management System (RMS) are: "AE" for
Architect-Engineer; "DO" for District Office
SECTION 15562A
Page 9
Previous Page
