NATIONAL FIRE PROTECTION ASSOCIATION (NFPA)
NFPA 31
(2001) Installation of Oil Burning
Equipment
NFPA 54
(2002) National Fuel Gas Code
NFPA 70
(2005) National Electrical Code
NFPA 8501
(1997) Single Burner Boiler Operation
THE SOCIETY FOR PROTECTIVE COATINGS (SSPC)
SSPC SP 5
(2000) White Metal Blast Cleaning
SSPC SP 6
(2000) Commercial Blast Cleaning
UNDERWRITERS LABORATORIES (UL)
UL 296
(2003; Rev thru Jan 2004) Oil Burners
UL 567
(2003) emergency Breakaway Fittings,
Swivel Connectors and Pipe-Connection
Fittings for Petroleum Products and LP-Gas
UL 574
(2003) Electric Oil Heaters
UL 726
(1995; Rev thru Jan 2001) Oil-Fired Boiler
Assemblies
UL 795
(1999) Commercial-Industrial Gas Heating
Equipment
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
submittal is sufficiently important or complex in
context of the project.
For submittals requiring Government approval on Army
projects, a code of up to three characters within
the submittal tags may be used following the "G"
designation to indicate the approving authority.
Codes for Army projects using the Resident
Management System (RMS) are: "AE" for
Architect-Engineer; "DO" for District Office
SECTION 15561A
Page 13
Previous Page
