basic designation only.
AMERICAN BEARING MANUFACTURERS ASSOCIATION (ABMA)
ABMA 11
(1990; R 1999) Load Ratings and Fatigue
Life for Roller Bearings
ABMA 9
(1990; R 2000) Load Ratings and Fatigue
Life for Ball Bearings
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI S2.19
(1999) Mechanical Vibration - Balance
Quality Requirements of Rigid Rotors, Part
1: Determination of Permissible Residual
Unbalance, Including Marine Applications
(Note: was ASA86, but that document refers
to ANSI S2.19.)
AMERICAN WATER WORKS ASSOCIATION(AWWA)
AWWA C200
(1997) Steel Water Pipe - 6 In. (150 mm)
and Larger
AWWA C203
(2002; A C203a-99) Coal-Tar Protective
Coatings and Linings for Steel Water
Pipelines - Enamel and Tape - Hot-Applied
AWWA C207
(2001) Steel Pipe Flanges for Waterworks
Service - Sizes 4 In. Through 144 In. (100
mm Through 3,600 mm)
AWWA C208
(2001) Dimensions for Fabricated Steel
Water Pipe Fittings
AMERICAN WELDING SOCIETY (AWS)
AWS D1.1/D1.1M
(2004) Structural Welding Code - Steel
ASME INTERNATIONAL (ASME)
ASME B46.1
(2002) Surface Texture, (Surface
Roughness, Waviness and Lay)
ASTM INTERNATIONAL (ASTM)
ASTM A 108
(2003) Steel Bars, Carbon, Cold-Finished
ASTM A 167
(2004) Stainless and Heat-Resisting
Chromium-Nickel Steel Plate, Sheet, and
Strip
ASTM A 176
(1999; R 2004) Stainless and
Heat-Resisting Chromium Steel Plate,
Sheet, and Strip
ASTM A 242/A 242M
(2004) High-Strength Low-Alloy Structural
Steel
SECTION 15132A
Page 6
Previous Page
