workmanship. In cases where the equipment manufacturer's advertised
minimum guarantee is in excess of 2 years, it shall remain in force for its
full period. Upon receipt of notice from the Government of failure of any
of the parts during the warranty period, new replacement parts shall be
furnished and installed promptly at no additional cost to the Government.
1.10
OPERATION AND MAINTENANCE
The Contractor shall furnish [_____] complete sets of instructions
containing the manufacturer's operation and maintenance instructions for
each piece of equipment to the Contracting Officer. Each set shall be
permanently bound and shall have a hard cover. One complete set shall be
furnished prior to field testing and the remaining sets shall be furnished
before the contract is completed. The following identification shall be
inscribed on the covers: "OPERATING AND MAINTENANCE INSTRUCTIONS," title of
the project, location of the project, the name of the Contractor, and the
contract number. A flysheet shall be placed before instructions covering
each subject. The instruction sheets shall be approximately 210 by 297 mm
8 1/2 by 11 inches, with large sheets of drawings folded in. The
instructions shall include, but not be limited to, the following:
a.
A cross-section drawing of the hydraulic cylinder with parts list.
b.
A system layout drawing showing the piping, valves, and controls.
c.
A system hydraulic schematic.
d.
Electrical wiring and control diagrams.
e.
Operating and maintenance instructions.
f.
Manufacturer's bulletins, catalog cuts, and descriptive data.
g.
Parts lists and recommended spare parts.
The Operation and Maintenance (O&M) Manual shall contain all information
which may be needed or useful for operation, maintenance, repair,
dismantling or assembling, and for identification of parts for ordering
replacements. The manual will be subject to approval.
1.11
SCHEMATIC AND DRAWINGS
1.11.1
Shop Drawings
Detailed shop drawings shall include fabrication, shop assembly, delivery,
and field installation drawings. Any component part of fabricated items
omitted shall be detailed on the shop drawings. If departures from the
contract drawings are deemed necessary by the Contractor, details of such
departures, including changes in related portions of the project and
reasons therefore, shall be submitted with the shop drawings.
1.11.2
Fabrication Drawings
Fabrication drawings shall be provided for all mechanical and structural
parts or components except those which are of standard manufacture. The
drawings shall show complete details of materials, tolerances, machined
surface finishes, connections, and proposed welding sequences which
differentiate shop welds and field welds.
SECTION 15010A
Page 14
Previous Page
