SD-10 Operation and Maintenance Data
Track beam system, Data Package 2; G
Hoist and trolley, Data Package 2; G
Submit in accordance with Section 01781 OPERATION AND
MAINTENANCE DATA.
1.4
QUALITY ASSURANCE
1.4.1
Certifications: Load Chain
Submit factory certification of load chain rated capacity.
1.4.2
Design Data: Design Calculations
Submit design calculations verifying the size of structural members,
structural support fittings, rods, brackets, components, and lifting beams
for the track beam system. The calculations shall include stress and
loading diagrams. Submit calculations with monorail drawings.
PART 2
PRODUCTS
2.1
FABRICATION AND CONSTRUCTION
Provide manual hoist and trolley, ASME HST-2, ASME HST-3, trolley
suspension. Trolley and wheels shall be suitable for operation on the
steel monorail track beam provided, and shall have not less than four
wheels.
2.1.1
Capacity
**************************************************************************
NOTE: Standard hoist capacities 1/4, 1/2, 1, 1-1/2,
2, 3, 4, 5, and 6 metric tons tons.
**************************************************************************
The hoist shall have a minimum rated capacity of [_____] metric tons tons.
The monorail system shall have a minimum rated capacity of [_____] metric
tons tons.
2.1.2
Hook Lift
**************************************************************************
NOTE: Do not specify a longer lift range than
required, as this will increase the building height
and hoist cost. The average lift for manual hoist is
2400 mm 8 feet. However, longer lifts are
commercially available at additional cost per foot.
Chain containers should be provided for lifts over
3000 mm 10 feet.
**************************************************************************
Shall be the manufacturer's standard. [The hoist lift shall be at its
highest point a minimum of [_____] m feet above the finished floor and at
its lowest point a minimum of [_____] m feet below the finished floor.]
SECTION 14534N
Page 6
Previous Page
