Hoistway Entrance Frames

2.9.1

**************************************************************************

NOTE: Coordinate materials with paragraph "ELEVATOR

DESCRIPTION".

**************************************************************************

1.8 mm thick14 gage 14 gage [stainless steel][ or ][prefinished carbon

sheet steel]. Solidly grout uprights of entrance ways to height of 1500 mm

5 feet.

2.9.2

Hoistway Entrance Sills

Provide one-piece cast solid white bronze or nickel silver entrance sills.

After sill is set level and flush with finished floor height, solidly grout

under full length of sill. Use same materaials for hoistway and car

entrance sills.

2.9.3

Hoistway Entrance Doors

ASME A17.1, Rule 110.11e, hollow metal non-vision construction with flush

surfaces on car and landing sides. Provide a minimum of 2 door guide

assemblies per door panel, one guide at leading edge and one at trailing

edge with guides in the sill groove the entire length of travel. Provide

sheet metal hoistway door track dust covers at each landing. Dust covers

must cover door locks and door roller tracks and extend the full width of

the door track and associated hardware.

2.9.4

Entrance Fascias and Dust Covers

ASME A17.1, Rule 110.10a and Rule 110.11a.

2.9.5

Hoistway Ventilation

Provide hoistway ventilation directly to outside air by fixed louver

through side wall of hoistway at highest possible point in hoistway. Net

size of louver to be at least 3 1/2 percent of hoistway cross section.

2.10

FREIGHT ELEVATOR GUIDES, PLATFORM, AND ENCLOSURE

**************************************************************************

NOTE: User roller guide assemblies on all freight

elevators.

**************************************************************************

2.10.1

Roller Guides

ASME A17.1, Section 200. Provide roller guide assemblies in adjustable

mountings on each side of car and counterweight frames in accurate

alignment to top and bottom of frames.

2.10.2

Car Frame and Platform

ASME A17.1, Section 203. Provide 1.8 mm thick 14 gage toe guard fascia on

car entrance side of platform in accordance with ASME A17.1, Rule 203.9.

SECTION 14210N

Page 25