sprinklers and piping with respect to the ceiling
and floor heat detectors, control panels, AFFF
control panel zoning, wiring, foam storage tank,
pumps, and other associated equipment.
Consider
pipe hanger requirements when laying out the system
to ensure that the Contractor can provide hangers
per NFPA 13.
**************************************************************************
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI A13.1
(1996; R 2002) Scheme for Identification
of Piping Systems
AMERICAN SOCIETY OF SANITARY ENGINEERING (ASSE)
ASSE 1013
(1999) Reduced Pressure Principle Backflow
Preventers and Reduced Pressure Fire
Protection Principle Backflow Preventers
AMERICAN WATER WORKS ASSOCIATION(AWWA)
AWWA C104
(1995) Cement-Mortar Lining for
Ductile-Iron Pipe and Fittings for Water
AWWA C110
(1998) Ductile-Iron and Gray-Iron
Fittings, 3 In. Through 48 In. (76 mm
through 1219 mm), for Water
AWWA C151
(2002) Ductile-Iron Pipe, Centrifugally
Cast, for Water
ASME INTERNATIONAL (ASME)
ASME B16.1
(1998) Cast Iron Pipe Flanges and Flanged
Fittings
ASME B16.3
(1998) Malleable Iron Threaded Fittings
ASME B16.4
(1998) Gray Iron Threaded Fittings
ASME BPVC SEC VIII D1
(2001) Boiler and Pressure Vessel Code;
Section VIII, Pressure Vessels Division 1
- Basic Coverage
SECTION 13955A
Page 5
Previous Page
