project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI C42.100
(2000) Standard Dictionary of Electrical
and Electronics Terms
ANSI INCITS 154
(1988; R 1999) Office Machines and
Supplies - Alphanumeric Machines-Keyboard
Arrangement
ANSI INCITS 92
(1981; R 1998) Data Encryption Algorithm
ELECTRONIC INDUSTRIES ALLIANCE (EIA)
EIA ANSI/EIA/TIA-232-F
(2002) Interface Between Data Terminal
Equipment and Data Circuit-Terminating
Equipment Employing Serial Binary Data
Interchange
INSTITUTE OF ELECTRICAL AND ELECTRONICS ENGINEERS (IEEE)
IEEE C2
(2002) National Electrical Safety Code
IEEE C62.41
(1991; R 1995) Recommended Practice for
Surge Voltages in Low-Voltage AC Power
Circuits
IEEE Std 142
(1992) Recommended Practice for Grounding
of Industrial and Commercial Power Systems
- Green Book
INTERNATIONAL TELECOMMUNICATION UNION (ITU)
ITU V.34
(1998) Data Communication Over the
Telephone Network: A Modem Operating at
Data Signaling Rates of up to 33,600 bits
for use on the General Switched Telephone
Network and on Leased Point-to-Point
Two-Wire Telephone Type Circuits
ITU V.42
(2002) Data Communications Over the
Telephone Network: Error-Correcting
Procedures for DCEs Using
Asynchronous-to-Synchronous Conversion
ITU V.42 bis
(1990) Data Communication over the
Telephone Network: Data Compression
Procedures for Data Circuit Terminating
Equipment (DCE) Using Error Correction
SECTION 13721A
Page 6
Previous Page
