1.4.2
Regulatory Requirements
1.4.2.1
Drawings:
Preengineered Building
Submit complete design drawings for the preengineered building.
Submit
drawings for the foundations and anchorage.
1.4.2.2
Design Data Building
Submit design calculations for the entire preengineered building and
foundations, prepared and stamped by a professional engineer. Also submit
for components requested, and stamp with the seal of a professional
engineer. Include sizes and location of anchor bolts.
1.4.3
Coordination Meeting
A coordination meeting shall be held within 45 days after contract award
for mutual understanding of the metal building system contract
requirements. This meeting shall take place at the building site and shall
include representatives from the Contractor, the roofing/metal building
system manufacturer, the roofing/metal building supplier, the erector, the
designer, and the Contracting Officer. All items required by paragraph
SUBMITTALS shall be discussed, including applicable standard manufacturer
shop drawings, and the approval process. The Contractor shall coordinate
time and arrangements for the meeting.
1.4.4
Instructions
1.4.4.1
Instruction Manuals
Manufacturer's literature for individual building component systems.
1.4.4.2
Erection
Manufacturer's erection instruction and erection drawings describing the
preparation requirements, assembly sequence, temporary bracing, shoring,
and related information necessary for erection of the metal building
including its structural framework and components.
1.4.5
Samples
1.4.5.1
Factory color Finish
Submit one sample of each color indicated for verification that the color
matches the colors indicated. Where colors are not indicated, submit not
less than four different samples of manufacturer's standard colors for
selection by the Contracting Officer.
1.4.5.2
Accessories
One sample of each type of flashing, trim, closure, cap and similar items.
Size shall be sufficient to show construction and configuration.
1.4.5.3
Roofing and Siding
One piece of each type and finish (exterior and interior) to be used, 225
mm 9 inches long, full width. The sample for factory color finished
covering shall be accompanied by certified laboratory test reports showing
that the sheets to be furnished are produced under a continuing quality
SECTION 13120
Page 19
Previous Page
