[_____] mg/L
[_____]:
[_____]
1.2.2
Design Criteria
**************************************************************************
NOTE: This paragraph specifies minimum design
requirements for continuous backwash, travelling
bridge, and pressure filtration systems.
**************************************************************************
Number of Filters:
[_____]
Maximum Effluent,
Suspended Solids:
[_____] mg/L
Maximum Effluent,
Particle Size:
[_____] micron
Maximum BOD:
[_____] mg/L
Backwash Type:
[_____]
Maximum Filtration Rate:
[_____]
L/second/square meter
Maximum Influent,
Pipe Velocity:
[_____]
m/s
Maximum Effluent,
Pipe Velocity:
[_____]
m/s
Clean Bed Maximum Headloss:
[_____]
meters
(at design flow and temperature)
Maximum Filtration Rate:
[_____]
gal/second/square foot
Maximum Influent,
Pipe Velocity:
[_____]
ft/s
Maximum Effluent,
Pipe Velocity:
[_____]
ft/s
Clean Bed Maximum Headloss:
[_____]
feet
(at design flow and temperature)
1.2.3
Cartridge and Bag Influent
**************************************************************************
NOTE: This paragraph describes influent flow
characteristics for cartridge and bag filtration
systems. In addition to the information listed
below, concentrations of Target Compound List (TCL)
and Target Analyte List (TAL) compounds in the waste
stream should be included in the influent stream
characteristics paragraph. This information will
help ensure that the bag or cartridge filtration
materials are compatible with the waste stream.
**************************************************************************
Design Flow:
[_____] L/minute
Maximum Flow Rate:
[_____] L/25 cm filter
equivalent
Design Inlet Pressure:
[_____] Pa
Design Influent Temperature:
[_____] degrees C
Maximum Influent Temperature:
[_____] degrees C
Minimum Influent Temperature:
[_____] degrees C
Fluid Viscosity:
[_____] cP
SECTION 11393
Page 10