1.5.2
Single Source Supplier
The Contractor shall assign to a single supplier full responsibility for
the furnishing of the adsorption system. The designated single supplier,
however, need not manufacture the system but shall coordinate the
selection, assembly, installation, and testing of the entire specified
system.
1.5.3
Manufacturer's Field Representative
Services of a manufacturer's field representative, who is experienced in
the installation, adjustment, and operation of the equipment furnished, and
who has complete knowledge of the proper operation and maintenance of the
system, shall be provided.
1.5.4
Welders
[Welders shall have passed qualification tests using procedures covered in
AWS B2.1 or ASME BPVC SEC IX and have the appropriate certification.]
[Qualifications of welders, and welding and nondestructive testing
procedures for piping shall be as specified in Section 05093 WELDING
PRESSURE PIPING.] [Structural members shall be welded in accordance with
Section 05090A WELDING, STRUCTURAL.] The Contractor shall require any
welder to retake the test when, in the opinion of the Contracting Officer,
the work of the welder creates reasonable doubt as to proficiency.
1.6
PARTNERING OR PRE-INSTALLATION CONFERENCE
[Partnering] [Pre-installation] conference [may] [will] be [requested]
[required]. The Contractor shall ensure that involved subcontractors,
suppliers, and manufacturers are [notified] [represented]. The date and
time of the conference shall be furnished to the Contracting Officer for
approval.
1.7
REGULATORY REQUIREMENTS
**************************************************************************
NOTE: Add applicable regional, state, or local
requirements. Section 01355A ENVIRONMENT PROTECTION
includes basic requirements.
**************************************************************************
The Contractor shall abide by the following requirements:
[_____].
1.8
DELIVERY, STORAGE, AND HANDLING
Equipment delivered and placed in storage shall be protected from the
weather, excessive humidity, excessive temperature variation, and dirt,
dust, or other contaminants. Catalyst material shall be protected in
accordance with the manufacturer's recommendations.
1.9
GENERAL REQUIREMENTS
Equipment and appurtenances shall be as specified and as shown on the
detail drawings, and shall be suitable for the service intended. Materials
and equipment shall be new and unused, except for testing equipment.
Components that serve the same function and are the same size shall be
identical products of the same manufacturer.
SECTION 11378
Page 15
Previous Page
