SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI C82.4
(2002) Ballasts for
High-Intensity-Discharge and Low-Pressure
Sodium Lamps (Multiple-Supply Type)
NATIONAL ELECTRICAL MANUFACTURERS ASSOCIATION (NEMA)
NEMA 250
(2003) Enclosures for Electrical Equipment
(1000 Volts Maximum)
NEMA ICS 1
(2000) Industrial Control and Systems:
General Requirements
NATIONAL FIRE PROTECTION ASSOCIATION (NFPA)
NFPA 70
(2005) National Electrical Code
U.S. ENVIRONMENTAL PROTECTION AGENCY (EPA)
EPA 625/1-86/021
(1986) Design Manual: Municipal
Wastewater Disinfection
1.2
SYSTEM DESCRIPTION
The ultraviolet (UV) disinfection system shall be complete and operational
with controls and accessories as shown and as specified. Equipment shall
be suitable for outdoor open channel, gravity flow installation and shall
include, but not be limited to, the following components, and appurtenances
necessary for the interconnection of components, in the quantities required:
(1)
UV lamp module with support rack and bracket.
(2)
UV system instrumentation, controls, and power distribution.
(3)
Wireway and interconnecting cables.
(4)
Water level control device.
(5)
UV intensity monitoring system.
(6)
Elapsed time meter.
(7)
Cleaning system.
(8)
Spare parts.
1.3
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
SECTION 11376
Page 4
Previous Page
