Cartridge filters
Activated carbon absorber
Multimedia filtration
Sludge dewatering equipment
In addition, these separators are not intended as
containment devices. Where applicable regulations
dictate containment of accidental spills, suitable
containment systems shall be designed.
**************************************************************************
**************************************************************************
NOTE: The following information shall be shown on
the project drawings:
1.
Inlet and outlet pipe invert elevations.
2. Sampling ports integral with the influent pipe
and effluent pipe, when required.
3. Accessory equipment.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN PUBLIC HEALTH ASSOCIATION (APHA)
APHA SMEWW
(1998) Standard Methods for the
Examination of Water and Wastewater
AMERICAN WELDING SOCIETY (AWS)
AWS D1.1/D1.1M
(2004) Structural Welding Code - Steel
ASME INTERNATIONAL (ASME)
ASME B16.5
(2003) Pipe Flanges and Flanged Fittings
ASTM INTERNATIONAL (ASTM)
ASTM A 36/A 36M
(2004) Carbon Structural Steel
ASTM E 165
(2002) Liquid Penetrant Examination
SECTION 11311
Page 4
Previous Page
