PART 2
PRODUCTS
2.1
FINISH
Finish surfaces, painted surfaces and painted items shall be in accordance
with BHMA A156.18 and as follows:
2.1.1
Painted Surfaces
600.
2.1.2
Finish Surfaces
626 or 630.
2.1.3
Painted Items
689.
2.2
KEYS AND CYLINDERS
BHMA A156.5.
2.2.1
Mogul Keys
Keys for pin tumbler locks shall be not less than 73 mm 2 7/8 inches in
length, blade shall be 14 mm 9/16 inch wide by 3.2 mm 1/8 inch thick.
Handle shall be 25 mm one inch in diameter. Stamp each key with number or
letter per code.
2.2.2
Mogul Cylinder
Provide a special "Mogul" cylinder approximately twice the diameter of a
commercial mortise lock cylinder with internal parts proportionately
larger. Special "Mogul" keys and restricted keying are required. The sale
of cut keys and blanks shall be factory regulated to control usage and
reproduction. The design shall be wear and pick resistant and shall
include a minimum of five stainless steel 4 mm 5/32 inch diameter pin
tumblers, stainless steel springs, and stainless steel ball bearings which
intermesh with the key and pin tumblers. Cylinder shall conform to UL 437.
2.2.3
Builders Cylinder
Type E09211A.
Keys shall be for restricted use.
Cylinder shall conform to
UL 437.
2.3
KEYING SYSTEM
Keying system shall consist of dissimilar combinations [for each building]
with external doors keyed alike; internal corridor doors keyed alike;
utility spaces, [wickets, and food passes] keyed alike; each group of cells
[or dormitory group] keyed alike but different from other groups. Establish
two separate detention key systems; one system shall be for the security
Mogul type hardware, and one for the paracentric key system.
2.4
DETENTION HINGES
Provide hinges in accordance with BHMA A156.1 and BHMA A156.7. Type A8191
HT with stainless steel maximum security pin. Type A8192 HT with stainless
SECTION 11194
Page 8
Previous Page
