2.1.1.1
Framing
Interior framing shall consist of [aluminum] [or] [galvanized steel] tube
columns welded to companion plates. Perimeter framing shall consist of
[aluminum] [or] [steel] angle framing welded to the post and plate system
as designed. Framing members shall be designed to permit [access to
electrical equipment] [and] [panel removal]. Mounting shall be provided as
shown. Framing members of steel shall be finished with semi-gloss baked
enamel or two-component acrylic polyurethane. Openings shall be sealed
from moisture and made tamper-proof.
2.1.1.2
Exterior Sheeting Panels
**************************************************************************
NOTE: If panels are to be nonremovable, use
aluminum panels to permit welding to frame. Details
will be used as applicable for locations for welding.
**************************************************************************
Modular panels shall be provided in sizes shown on drawings. Panels shall
be fabricated a minimum of [2.3 mm 0.090 inch thick [aluminum] [steel]] [
3.2 mm 0.125 inch thick fiberglass reinforced plastic (FRP)]. [Panels
shall be heliarc welded to framing system [_____].] Top and end panels
shall be removable and shall be secured by 5 mm 3/16 inch socket head jack
nuts. Finish for metal panels shall be [semi-gloss baked enamel]
[two-component acrylic polyurethane] [anodized conforming to AA DAF-45].
2.1.1.3
Mounting
Mounting shall be provided by securing to concrete foundation as shown.
2.1.1.4
Base finish shall be [semi-gloss baked enamel] [or] [two-component acrylic
polyurethane] [anodized conforming to AA DAF-45] [_____]. Metal panel
system finish shall be [baked enamel or two-component acrylic polyurethane]
[anodized conforming to AA DAF-45 [_____], as shown].
2.1.2
Panel And Post/Panel Type Signs
**************************************************************************
NOTE: Show details of sign foundations on drawings.
Include provision for concealed entry of electric
service to internally illuminated signs through
foundation to post.
**************************************************************************
2.1.2.1
Posts
One-piece [aluminum] [or] [galvanized steel] posts shall be provided with
minimum 3.2 mm 0.125 inch wall thickness. Posts shall be designed to
accept panel framing system described. The post shall be designed to
permit attachment of panel framing system without exposed fasteners. Caps
shall be provided for each post.
2.1.2.2
Panel Framing System
Panel framing consisting of aluminum sections and interlocking track
components shall be designed to interlock with posts with concealed
SECTION 10430
Page 9
Previous Page
