Exterior Signage[; G][; G, [_____]]
Exterior signage schedule in electronic media with spread sheet
format. Spread sheet shall include sign location, sign type, and
message.
Wind Load Requirements
Design analysis and supporting calculations performed in support
of specified signage.
SD-04 Samples
Exterior Signage[; G][; G, [_____]]
One 300 mm 12 inch length of framing for illuminated signs. One
sample of [each type of sign] [_____]. Each sample shall consist
of a complete sign panel with letters and symbols. Samples may be
installed in the work, provided each sample is identified and
location recorded. [Three][_____] color samples for each material
requiring color and 305 mm 12 inch square sample of sign face
color sample.
SD-10 Operation and Maintenance Data
Protection and Cleaning
[Six] [_____] copies of maintenance instructions listing routine
maintenance procedures, possible breakdowns and repairs, and
troubleshooting guides. The instructions shall include simplified
diagrams for the equipment as installed.
1.3
GENERAL
All exterior signage shall be provided by a single manufacturer. Exterior
signage shall be of the design, detail, sizes, types, and message content
shown on the drawings, shall conform to the requirements specified, and
shall be provided at the locations indicated. Signs shall be complete with
lettering, framing as detailed, and related components for a complete
installation. Recyclable materials shall conform to EPA requirements in
accordance with Section 01670 RECYCLED / RECOVERED MATERIALS.
1.4
WIND LOAD REQUIREMENTS
Exterior signage shall be designed to withstand [_____] km/h mph windload.
1.5
CHARACTER PROPORTIONS AND HEIGHTS
Letters and numbers on indicated signs for handicapped-accessible buildings
shall have a width-to-height ratio between 3:5 and 1:1 and a
stroke-width-to-height ratio between 1:5 and 1:10. Characters and numbers
on indicated signs shall be sized according to the viewing distance from
which they are to be read. The minimum height is measured using an upper
case letter "X". Lower case characters are permitted.
1.6
QUALIFICATIONS
Signs, plaques, and dimensional letters shall be the standard product of a
manufacturer regularly engaged in the manufacture of the products. Items
SECTION 10430
Page 7
Previous Page
