For submittals requiring Government approval on Army
projects, a code of up to three characters within
the submittal tags may be used following the "G"
designation to indicate the approving authority.
Codes for Army projects using the Resident
Management System (RMS) are: "AE" for
Architect-Engineer; "DO" for District Office
(Engineering Division or other organization in the
District Office); "AO" for Area Office; "RO" for
Resident Office; and "PO" for Project Office. Codes
following the "G" typically are not used for Navy
projects.
Submittal items not designated with a "G" are
considered as being for information only for Army
projects and for Contractor Quality Control approval
for Navy projects.
**************************************************************************
Government approval is required for submittals with a "G" designation;
submittals not having a "G" designation are [for Contractor Quality Control
approval.][for information only. When used, a designation following the
"G" designation identifies the office that will review the submittal for
the Government.] The following shall be submitted in accordance with
Section 01330 SUBMITTAL PROCEDURES:
SD-03 Product Data
Gypsum base
Gypsum veneer plaster
Descriptive data and installation instructions.
1.4
DELIVERY AND STORAGE
Deliver and store plaster materials in the manufacturer's original unopened
containers. Store materials off the ground within a completely enclosed
structure or enclosed within a weathertight covering. Store gypsum base
and gypsum backing board flat to prevent warping and protect from excessive
exposure to sunlight.
1.5
SCHEDULING
Commence application only after the area scheduled for veneer plaster work
is completely weathertight. The heating, ventilating, and air-conditioning
systems should be complete and in operation prior to application of the
plaster. If the mechanical system cannot be activated before veneer
plastering is begun, the plastering may proceed in accordance with an
approved plan to maintain the environmental conditions specified below.
Apply plaster prior to the installation of finish flooring and acoustic
ceiling.
1.6
ENVIRONMENTAL REQUIREMENTS
**************************************************************************
NOTE: Veneer plaster is a very thin coating that
will be adversely affected by extreme or non-uniform
drying conditions and by rapid changes in
SECTION 09215
Page 6
Previous Page
