SECTION 09215 VENEER PLASTER

**************************************************************************

USACE / NAVFAC / AFCESA

UFGS-09215 (September 2003)

------------------------------

Preparing Activity: NAVFAC

Superseding

UFGS-09215A (November 1995)

UFGS-09215N (September 1999)

UNIFIED FACILITIES GUIDE SPECIFICATIONS

References are in agreement with UMRL dated 23 June 2005

Latest change indicated by CHG tags.

**************************************************************************

SECTION 09215

VENEER PLASTER

09/03

**************************************************************************

NOTE: This guide specification covers the

requirements for veneer plaster systems.

Comments and suggestions on this guide specification

are welcome and should be directed to the technical

proponent of the specification. A listing of

technical proponents, including their organization

designation and telephone number, is on the Internet.

Recommended changes to a UFGS should be submitted as

a Criteria Change Request (CCR).

Use of electronic communication is encouraged.

Brackets are used in the text to indicate designer

choices or locations where text must be supplied by

the designer.

**************************************************************************

NOTE: Veneer plaster consists of a 2 to 3 mm 1/16

to 1/8 inch thick plaster coating applied in one or

more coats to a special gypsum lath base over metal

or wood framing. Veneer plaster provides a hard,

dense finish for areas such as corridors and

conference rooms of major facilities where walls are

subjected to frequent impact and where appearance is

important. It should not be used in shower rooms or

excessively humid areas.

**************************************************************************

NOTE: On the drawings, indicate location and extent

of each type of veneer plaster and control joints.

**************************************************************************

SECTION 09215

Page 3