bullet-resisting, wire, figured, plate, and spandrel
glass.
6. Locations of insect screens and storm windows,
if any
7.
Locations of fire-rated windows, if required
8.
Number and location of window cleaners' anchors
9.
Number and location of extension crank operators
10. If motorized operators are required, show on
electrical drawings and specify in Division 16.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI B18.6.3
(1972; R 1997) Machine Screws and Machine
Screw Nuts
ANSI B18.6.4
(1981) Thread Forming and Threaded Cutting
Tapping Screws and Metallic Drive Screws
(Inch Series)
ASME INTERNATIONAL (ASME)
ASME A39.1
(1995; A39.1a; A39.1b) Safety Requirements
for Window Cleaning
ASTM INTERNATIONAL (ASTM)
ASTM A 123/A 123M
(2002) Zinc (Hot-Dip Galvanized) Coatings
on Iron and Steel Products
ASTM A 167
(2004) Stainless and Heat-Resisting
Chromium-Nickel Steel Plate, Sheet, and
Strip
ASTM A 569/A 569M
(1998) Steel, Carbon (0.15 Maximum
Percent), Hot-Rolled Sheet and Strip,
Commercial
SECTION 08510
Page 4
Previous Page
