PART 2
PRODUCTS
2.1
MATERIALS
Only structural quality steel materials for which tension properties have
been obtained shall be used to resist blast except that commercial quality
steel sheet and strip shall be permitted for prototype tested hollow metal
doors. Steel used in the door, door frame, and door frame anchors and non
stainless steel fasteners that resist blast shall be selected from the
materials specified.
2.1.1
Concrete and Concrete Reinforcement
**************************************************************************
NOTE: Retain this paragraph when reinforced
concrete doors are specified.
**************************************************************************
Concrete is specified in Section [03300A CAST-IN-PLACE STRUCTURAL CONCRETE][
03300N CAST-IN-PLACE CONCRETE]. Concrete reinforcement shall conform to
ASTM A 615/A 615M or ASTM A 706/A 706M, Grade 60.
2.1.2
Structural Tubing
**************************************************************************
NOTE: Retain this paragraph when structural steel
or hollow metal doors are specified.
**************************************************************************
Structural tubing shall conform to ASTM A 500, ASTM A 501, or ASTM A 618.
2.1.3
Structural Steel
**************************************************************************
NOTE: For reinforced concrete and hollow metal
doors, specify only ASTM A 36/A 36M.
**************************************************************************
Structural steel bars, plates, and shapes shall conform to ASTM A 36/A 36M,
ASTM A 242/A 242M, ASTM A 529/A 529M, ASTM A 572/A 572M, or ASTM A 588/A
588M. Quenched and tempered steel plate shall conform to ASTM A 514/A 514M.
2.1.4
Steel Sheet and Strip
**************************************************************************
NOTE: Retain this paragraph when hollow metal doors
are specified.
**************************************************************************
Steel sheet and strip shall conform to ASTM A 653/A 653M, Grades A, B, C,
D, and F; ASTM A 653/A 653M; ASTM A 606; or ASTM A 792/A 792M, Grades 33,
37, 40, and 50.
2.1.5
Fasteners
Steel studs and bolts shall conform to ASTM A 307, ASTM A 325M ASTM A 325,
ASTM A 354, ASTM A 449, or ASTM A 490M ASTM A 490 as applicable. Steel
nuts shall conform to ASTM A 563M ASTM A 563. Hardened circular, beveled,
and clipped washers shall conform to ASTM F 436MASTM F 436. Steel hex cap
SECTION 08390
Page 16