NOTE: Use a shrouded padlock in conjunction with a
hasp conforming to MIL-DTL-29181.
**************************************************************************
High security padlocks with shrouded shackles shall conform to MIL-DTL-43607.
2.2.9
Hasp
Low security hasps shall conform to BHMA A156.20, Grade [1] [2] [3], steel,
[safety] [or] [open hinge] type with [adjustable] [,] [or] [swivel] [,]
[or] [fixed] staple, [paint finished] [or] [galvanized] [as specified] and
screw fastened to the door and frame.
2.2.10
High Security Hasp
**************************************************************************
NOTE: This high security hasp is a non-shrouded
mortise type. Styles 1 through 9 are available.
Consult referenced military specification.
**************************************************************************
High security hasps shall conform to MIL-DTL-29181, Style [_____] [carbon]
[corrosion resistant] steel, attached by [fasteners] [welding].
2.2.11
Shrouded Hasp
**************************************************************************
NOTE: Style 1 applies to right-hand doors and Style
2 to left-hand doors.
**************************************************************************
High security shrouded hasps shall conform to MIL-DTL-29181, Style [1] [or]
[2] [as applicable].
2.2.12
Door Stop
Door stops shall be designed to resist the impact of the door. The stop
shall not scratch or scar the door finish when the door is opened against
the stop.
2.2.13
Surface Door Closer
**************************************************************************
NOTE: Door closers are practical only for hollow
metal doors and light structural steel doors.
**************************************************************************
The surface door closer shall conform to BHMA A156.4.
The size and grade
shall be selected by the door manufacturer.
2.2.14
Overhead Door Holder
Overhead door holder shall be surface mounted. The holder shall have a
spring or other device to cushion the door action and shall limit the door
swing at [85] [110] degrees. [The holder shall have a built-in, hold-open
capability at the swing limit specified.] [Overhead door holders for hollow
metal doors weighing less than 90 kg 200 pounds shall conform to BHMA A156.8.]
SECTION 08390
Page 21
Previous Page
