5.
Design wind loads required for building
6. Profile of door panel if important.
Do not use
proprietary profile.
7.
Size and location of glazed panels
8. Location of motors and control stations.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
ASTM INTERNATIONAL (ASTM)
ASTM A 123/A 123M
(2002) Zinc (Hot-Dip Galvanized) Coatings
on Iron and Steel Products
ASTM A 227/A 227M
(1999) Steel Wire, Cold-Drawn for
Mechanical Springs
ASTM A 229/A 229M
(1999) Steel Wire, Oil-Tempered for
Mechanical Springs
ASTM A 36/A 36M
(2004) Carbon Structural Steel
ASTM A 653/A 653M
(2004a) Steel Sheet, Zinc-Coated
(Galvanized) or Zinc-Iron Alloy-Coated
(Galvannealed) by the Hot-Dip Process
ASTM B 209
(2004) Aluminum and Aluminum-Alloy Sheet
and Plate
ASTM B 209M
(2004) Aluminum and Aluminum-Alloy Sheet
and Plate (Metric)
ASTM B 221
(2004a) Aluminum and Aluminum-Alloy
Extruded Bars, Rods, Wire, Profiles, and
Tubes
ASTM B 221M
(2004) Aluminum and Aluminum-Alloy
Extruded Bars, Rods, Wire, Profiles, and
Tubes (Metric)
ASTM C 236
(1989; R 1993e1) Steady-State Thermal
SECTION 08361
Page 4
Previous Page
