Submit for materials to be provided. Submit data sufficient to
indicate conformance to specified requirements.
SD-04 Samples
Roofing panel
Submit a 300 mm 12 inch long by full width section of typical
panel.
[
For color selection, submit 50 by 100 mm 2 by 4 inch metal
samples in color, finish and texture [specified] [selected].
[When colors are not indicated, submit samples of not less than
six different manufacturer's standard colors for selection.]]
Accessories
Submit each type of accessory item used in the project
including, but not limited to each type of anchor clip, closure,
fastener, and leg clamp.
Sealants
Intermediate Support Section
Submit full size samples of each intermediate support section,
300 mm 12 inches long.
SD-05 Design Data
Design calculations
SD-06 Test Reports
Field Inspection; G
Submit manufacturer's technical representative's field
inspection reports as specified in paragraph entitled
"Manufacturer's Field Inspection."
**************************************************************************
NOTE: This paragraph requires certified test
reports for structural and finish tests. If there
is reason to require a factory test report for other
tests, modify this paragraph accordingly.
**************************************************************************
Structural performance tests
Finish tests
SD-07 Certificates
Manufacturer's Technical Representative's Qualifications
Statement of Installer's Qualifications
Submit documentation from roofing manufacturer proving the
SECTION 07611N
Page 11
Previous Page
