designation to indicate the approving authority.
Codes for Army projects using the Resident
Management System (RMS) are: "AE" for
Architect-Engineer; "DO" for District Office
(Engineering Division or other organization in the
District Office); "AO" for Area Office; "RO" for
Resident Office; and "PO" for Project Office. Codes
following the "G" typically are not used for Navy
projects.
Submittal items not designated with a "G" are
considered as being for information only for Army
projects and for Contractor Quality Control approval
for Navy projects.
**************************************************************************
Government approval is required for submittals with a "G" designation;
submittals not having a "G" designation are [for Contractor Quality Control
approval.][for information only. When used, a designation following the
"G" designation identifies the office that will review the submittal for
the Government.] The following shall be submitted in accordance with
Section 01330 SUBMITTAL PROCEDURES:
SD-02 Shop Drawings
Roofing; G
Submit roofing drawings to supplement the instructions and
diagrams. Drawings shall include design and erection drawings
containing an isometric view of the roof showing the design uplift
pressures and dimensions of edge, ridge and corner zones; and show
typical and special conditions including flashings, materials and
thickness, dimensions, fixing lines, anchoring methods, sealant
locations, sealant tape locations, fastener layout, sizes, and
spacing, terminations, penetrations, attachments, and provisions
for thermal movement. Details of installation shall be in
accordance with the manufacturer's Standard Instructions and
details or the SMACNA Arch. Manual. Prior to submitting shop
drawings, have drawings reviewed and approved by the
manufacturer's technical engineering department.
SD-03 Product Data
Roofing panels; G
Attachment clips
Closures
Accessories
Fasteners
Sealants
[
Insulation, including joint sealing measures for vapor barrier
facing]
Sample warranty certificate; G
SECTION 07611N
Page 10
Previous Page
