locations, head joint vent locations, flashing,
reinforcement locations and details, anchor details,
special unit details, masonry dimensions, design
loadings when applicable, section properties of
steel studs and other cold-formed steel framing
members, and other similar details to complement
this guidance.
**************************************************************************
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN INSTITUTE OF STEEL CONSTRUCTION (AISC)
AISC 316
(1989) ASD Manual of Steel Construction
AMERICAN IRON AND STEEL INSTITUTE (AISI)
AISI SG-971-Spec
(1996) Specification and Commentary for
the Design of Cold-Formed Steel Structural
Members and Commentary; includes SG-2000-1
Supp 1 to 1996 Spec, dated 2000
AMERICAN SOCIETY OF HEATING, REFRIGERATING AND AIR-CONDITIONING
ENGINEERS (ASHRAE)
ASHRAE Fundamentals Handbook
(2001) Fundamentals Handbook
AMERICAN WELDING SOCIETY (AWS)
AWS D1.3
(1998) Structural Welding Code - Sheet
Steel
ASTM INTERNATIONAL (ASTM)
ASTM A 123/A 123M
(2002) Zinc (Hot-Dip Galvanized) Coatings
on Iron and Steel Products
ASTM A 153/A 153M
(2004) Zinc Coating (Hot-Dip) on Iron and
Steel Hardware
ASTM A 36/A 36M
(2004) Carbon Structural Steel
ASTM A 653/A 653M
(2004a) Steel Sheet, Zinc-Coated
(Galvanized) or Zinc-Iron Alloy-Coated
(Galvannealed) by the Hot-Dip Process
SECTION 04810
Page 4
Previous Page
