1.12
WARRANTY
Furnished play events and equipment shall have a minimum 1 year calendar
period warranty.
1.13
TECHNICAL REPRESENTATIVE
1.13.1
Playground Areas Other Than Child Development Centers (CDC)
The technical representative for outdoor play areas on sites other than
CDCs shall be the Director of Public Works or designated representative.
The design of these outdoor play areas shall be based on the play program
and the age groups to be accommodated as determined by the play area
committee.
1.13.2
Child Development Centers (CDC)
The technical representative for outdoor play areas at CDC is the
installation Child Development Services (CDS) Coordinator. The design of
the CDC outdoor play area shall be based on the developmental play program
for the age groups accommodated at the CDC. The play area is designed to
support the CDC program and to provide a stage set for creative play.
Developmental activities are selected which promote the intellectual,
social, emotional and physical growth of the children. The developmental
play program is developed by the MACOM CDS Director, installation CDS
Coordinator and CDC Director. They are responsible for the developmental
play program and the selection of play events to meet that program.
1.14
MANUFACTURER'S REPRESENTATIVE
The manufacturer's certified playground safety inspector or the
manufacturer's designated certified playground safety representative shall
supervise the installation and adjustment of the play events and equipment
to verify the installation meets the requirements of the manufacturer, this
specification, and paragraph CHILD SAFETY AND ACCESSIBILITY STANDARDS.
PART 2
PRODUCTS
2.1
MATERIALS
Materials shall be the standard products of a manufacturer regularly
engaged in the manufacture of play event products.
2.1.1
Metal
Metal components shall have factory-drilled holes and be corrosion
resistant. The components shall be free of excess weld and spatter.
Metallic materials shall conform to Section 05500A MISCELLANEOUS METAL.
Components with extra holes not filled by hardware or covered by components
shall be rejected.
2.1.1.1
Steel
Steel components shall comply with ASTM A 135, ASTM A 500, or ASTM A 513.
Minimum tensile strength shall be 310 Mpa 45,000 psi. Minimum yield point
shall be 225 Mpa 33,000 psi.
SECTION 02882
Page 13
Previous Page
