tongue and grooved, beveled or square cut wood staves.
Attach wood staves
to metal frame from inside with steel plated screws.
a.
Wood species: Kiln dried, maximum 19 percent moisture content,
[Clear All Heart California Redwood] [Western Yellow Cedar] [Red
Oak] [Phillipine Mahogany] [Purple Heart] [Ipe].
b.
Metal frame: Reinforced with steel bars as per manufacture's
standard construction, black color factory finish coated.
c.
Bottom: 6.25 mm 1/4 inch exterior grade redwood with drain holes.
[d.
Liners:
Removable galvanized steel or manufacturer's standard.]
[e.
Tops: [Hinged top opening] [spun aluminum open top with molded
rim] [ash top]].
]2.8.5
Fiberglass Planters [Waste Receptacles] [Ash Receptacles]
Provide reinforced fiberglass planters [waste receptacles] [ash
receptacles] molded with multiple laminations of glass fiber impregnated
with polyester isophthalic thermosetting resins; with 0.30-0.38 mm 12-15 mil
color impregnated polyester gel coat finish; minimum thickness of 6.35 mm
1/4 inch; color as selected.
2.8.6
Metal Planters [Waste Receptacle]
Provide metal planters [waste receptacles] as indicated, fabricated from
[perforated steel sheet material] [wire or diamond mesh steel sheet] [steel
frame with steel staves welded to frame] [cast aluminum] [ cast iron];
powder coat finish, color as selected.
a.
Metal thickness, width, and configuration shall be manufacturer's
standard. Chemically clean and phosphate coat prior to final
powdercoat.
b.
Provide 5 mm 3/16 inch thick fiberglass-reinforced polyester resin
liner in black for planter liners.
2.9
SHELTERS
**************************************************************************
NOTE: It is important that the drawings reflect the
type and size of Shelter intended. The
specifications are intended to cover everything from
small BUS STOP SHELTERS to large PAVILION SHELTERS.
Types of structural frames, roofing materials and
facias, glazing systems, and foundations must be
carefully coordinated with the drawings. These
systems are all factory designed and prefabricated
ready for site assembly.
**************************************************************************
AISC 350; AISC 335. Provide prefabricated shelter systems to meet design
conditions indicated. Shelter design shall conform to all applicable State
and Local Building Codes and shall meet manufacturer's standards of
construction and materials. Shelter systems shall be [preglazed]
pre-drilled and pre-cut, shipped with all hardware and accessories
necessary for complete field assembly.
SECTION 02870
Page 25
Previous Page
