][2.6.2
Precast Concrete Bicycle Rack
Provide one-piece precast concrete bicycle rack base with embedded
galvanized metal hitching loops. Design bicycle rack with wheel notches
for bike support and wheel locking device.
]2.7
BOLLARDS
**************************************************************************
NOTE: Bollards are often included as a site
furnishing but function primarily as a vehicle
barrier; for bollard specification, verify cross
reference with Section 02840 ACTIVE VEHICLE BARRIERS.
**************************************************************************
2.7.1
Precast Concrete Bollards
Provide reinforced concrete bollards [300] [450] mm [12] [18] inch [square]
[round], height as indicated, suitable for ground mount installation.
Provide exposed aggregate or sandblast finish as indicated; manufacturer's
standard clear acrylic sealer.
a.
Portland cement:
ASTM C 150 Type I II or III.
b.
Aggregate:
ASTM C 33, maximum size 19 mm 3/4 inch.
c.
Reinforcing steel:
ASTM A 615/A 615M.
d.
Integral color:
ASTM C 979, pure mineral oxide, limeproof and
non-fading.
e.
Concrete strength: 35 MPa 5000 psi, 28 day minimum compressive
strength.
f.
Admixture:
ASTM C 260 for air-entraining.
2.8
PLANTERS [WASTE RECEPTACLES] [ASH RECEPTACLES]
[Provide for waste receptacles [spun aluminum] [reinforced fiberglass]
[flat] [domed] tops and removable semi-rigid plastic liner insert.]
[Provide top-mounted ash trays for ash receptacles.] Waste receptacles
shall be furnished with weather protection, odor containment, and
insect/animal-proofing. Container size shall be [as directed] [_____].
a. Height: Trash and litter deposit openings shall be between 800-1000
mm 30-40 inches above the ground.
b. Liners: Trash and litter receptacles shall be furnished with
[disposable inner-linings] [removable/reusable inner containers].
Self-dumping type designs to include hinged bottom, top or sides will
be rejected.
c. Anchors: Trash and litter receptacles that can be anchored to
resist overturning by typical use, high winds, or animals shall be
furnished and anchored in accordance with the manufacturer's
recommendations.
d. Openings: Openings for trash and litter insertion shall be a
minimum of 100 mm 4 inches in diameter. Edges of the openings shall be
SECTION 02870
Page 22
Previous Page
