O.D. by 1.6 mm 16 gage] galvanized tubing for bench frames.
[c.
Provide 48.2 mm 1 1/2 inch O.D. by 3.1 mm 11 gage galvanized
tubing for armrest.]
d.
Provide cadmium or zinc plated hardware; nuts, bolts, screws, and
lock washers with a clean chromate finish.
]2.5.5
Aluminum Units
[AA DAF-45] [AAMA 611]. Provide [extruded] [formed] aluminum benches as
per manufacturers standard, with [dark] [medium] [light] bronze [clear
anodized] [black anodized] [acrylic paint] [powder coat] finish, color as
selected from manufacturer's standards.
a.
Design benches to sustain a live load of not less than 10 kPa 200
pounds per square foot.
b.
Provide manufacturer's standard [cast grey iron] [cast aluminum]
[steel] [precast concrete] [fiberglass] pedestals.
2.5.6
Accessoriess
Provide manufacturer's standard materials and accessories as required for
assembly of units and as indicated on the assembly drawings. Provide
unexposed aluminum, stainless steel or steel plates, angles and supports as
required for complete assembly. Separate dissimilar materials to prevent
electrolytic action.
2.5.7
Fasteners
Provide concealed fasteners except where specifically approved; types as
required for specific usage.
2.5.8
Anchoring Brackets
Provide 6 mm 1/4 inch zinc plated steel angle anchoring brackets, 47 mm 1
7/8 inch wide by 50 mm 2 inches deep by 63 mm 2 1/2 inches high [47 mm 1
7/8 inch wide by 90 mm 3 1/2 inch deep by 150 mm 6 inch high], pre-drilled
for bolting benches to substrate.
2.6
BICYCLE RACKS
Design bicycle racks (stanchions) in accordance with manufacturer's
standards and to meet design conditions indicated. Locate as shown on the
drawings. Provide powder coat finish in color as selected from
manufacturer's standards. Racks shall accommodate locking devices and
secure, as a minimum, one wheel and part of the frame simultaneously. The
spacing between racks shall be a minimum of 610 mm 24 inches.
[2.6.1
Metal Pipe Bicycle Racks
Provide ASTM A 53/A 53M schedule 40 steel pipe bicycle racks in
configuration and of [114] [_____] mm [4 1/2] [_____] inch pipe size. Type
of mounting, bicycle rack capacity and height above the ground as shown on
the drawings.
SECTION 02870
Page 21
Previous Page
