designation to indicate the approving authority.
Codes for Army projects using the Resident
Management System (RMS) are: "AE" for
Architect-Engineer; "DO" for District Office
(Engineering Division or other organization in the
District Office); "AO" for Area Office; "RO" for
Resident Office; and "PO" for Project Office. Codes
following the "G" typically are not used for Navy
projects.
Submittal items not designated with a "G" are
considered as being for information only for Army
projects and for Contractor Quality Control approval
for Navy projects.
**************************************************************************
Government approval is required for submittals with a "G" designation;
submittals not having a "G" designation are for [Contractor Quality Control
approval.] [information only. When used, a designation following the "G"
designation identifies the office that will review the submittal for the
Government.] The following shall be submitted in accordance with Section
01330 SUBMITTAL PROCEDURES:
SD-04 Samples
Concrete Paving Block[; G][; G, [_____]]
A sample of five paving blocks prior to the start of the work.
Also, a representative sample of not less than 15 blocks as
directed by the Contracting Officer, from each lot of 20,000
concrete paving blocks or fraction thereof.
SD-06 Test Reports
Tests, Inspections and Verifications
A written report within 7 calendar days after completion of the
work, covering the testing required for each lot.
1.3
BASIS FOR PAYMENT
**************************************************************************
NOTE: Delete this paragraph in fixed price
contracts.
**************************************************************************
1.3.1
Pavements
The blocks, cut blocks, bedding sand, and jointing sand will be paid per
square meter foot of satisfactorily installed block pavement surface.
1.3.2
Edge Restraint
The edge restraint will be paid per lineal meter foot of satisfactorily
installed edge restraint.
1.4
MAINTENANCE
**************************************************************************
SECTION 02780
Page 5
Previous Page
